I purchased the main engine wiring harness and needed these to adapt that because I upgraded the UVC wiring a couple years ago. I payed for overnight delivery and they delivered, thank you.

Fit perfectly, good quality wire not the cheap crap.

High quality replacement used these to convert my OBS to the newer single plug gaskets. Perfect fit and quality. Excellent results much easier to deal with over the 4 single plugs.

works great. Fixed the problems I was having

Upgraded my 1997 to get away from having two connectors per cover and get the larger pins for the GPs. The old set up isn't sufficient for the amps pulled by the GPs and melts over time. I recommend doing this instead of sticking with the stock 97 set up, Just be sure to solder and heat shrink your wire connections.

Fits as it should. Good snug connection.

This plug wired right in (colors not the same so just match it up properly) but the plug fits into OEM UVCH perfectly and fixes any issues you may have from worn out pigtails.

Bought these for my OBS along with the under valve cover harness and VC gaskets to convert to a single plug. OEM quality for sure, can't wait to get these bad boys installed!

I bought these to ensure longevity when refurbishing the engine harness so I had the harness on a bench when I soldered them on. The wires and insulation were more robust on these than the OEM ones I cut off unlike cheap pigtails you buy that have undersized wires.. The colors did not match the OEM wire colors but it was not an issue. You could replace these without removing the engine harness but the amount of time you save by not removing the harness will likely be negated by having to work in the engine bay. Excellent, high quality, oem, completely satisfied. Don't forget to put your heat shrink in place before you start soldering!