Sure makes it easy to tell where your set at.

Works great! Let's me know what mode I'm in.

1. Using a 2mm hex key remove the grub screw from the knob and remove the knob.
2. Remove the brass nut and locking washer from the knob (this will become the hold down for the TS plate)
3. Using a razor or cutters clip off the small raised plastic cylinder that prevents the plate from sitting flush
4. Install the plate first with lock washer and nut installed snug but not too tight so the plate can be adjusted after the knob is reinstalled
5. Reinstall the knob and tighten the grub screw snug but not too tight, adjust the plate so the numbers matchup best with the line on the knob
6. Remove knob and tighten plate to final position
7. Reinstall knob and fully tighten grub screw

The numbers don’t line up perfectly but the install was smooth and the lineup is not too bad to make it unreadable

Works well

this plate makes the knob of your TS look like part of the Dash*****

switch ling up nice. some reason the 6 position is a little tight to select with the new plate not sure why. I like it!

I would always forget what tune I was on and would have to click it to 1 then back up. Now I can just easily see it at a glance. Good idea, and nice product.

Good way to know what tune you are in, nice quality, 30 second install.

Waste of 12 bucks. The numbers dont even line up to what setting your on.