Mag-Hytec Deep Transmission Pan
• Deep high-capacity sump for maximum cooling
• Magnetic drain plug
• 303 hardware except allen head cap screws are zinc plated
• 1/8 NPT temperature sender port
• Finned aircraft aluminum construction
• Requires only three allen key wrenches (included) for installation and service
• O-rings require no gaskets or sealants
• Holds 7.6 quarts more fluid than stock pan
Overall height 6 1/8″
1990 to 2003 F150, F250, F350, F450, F550, F650, Trucks, Excursion, Vans, Motor homes.
Excursion cross member must be moved back 1/4"
All 7.3 Liter Diesels to 2003
All V10 Gas to 2004 (until 3 valve V10), 2004 Lightning and Vans
--
Attention EXCURSION Owner:
This application will require some modifications of the transmission cross member. There are many different ideas and each will have it’s merits and difficulties.
My suggestion would be to slot the bolt holes on the cross member to allow it to move toward the rear of the truck for clearance. (NOT THE FRAME, but the cross member) The #F4R100 pan will bolt onto the transmission and then you will see how long you will need to make the slots.
Some others have cut a relief in the cross member (Not my favorite idea.) Also some have ground the fins down on the pans, and cut the cross member, this is not the worst idea but again whatever will work should be looked at.
This will be a project requiring tools and skills that are advanced.
Write a Review
-
Easy install. Tranny runs much better and doesn’t get as hot when towing.
-
easy install, great fit 2002 f350 4wd, temp 5-10 deg cooler depending on load
-
Delivery was fast even though it was not in stock, way to go Clay. Install was straight forward and the higher capacity seems to have helped drop temps about 10 degrees on a trip to my sisters on a hot day. I would buy again.
-
Great product very well built with clear precise instructions. The Truck this is going on does a lot of bush miles down here in Australia and the extra oil in the tranny helps big time. Thank you. Riffraf are second to none for customer service and help Thank you team.
-
Very high quality product, installed this with a high capacity trans cooler and am very happy with the results.
-
great product, fitment was smooth, good instructions, and like always fast professional delivery...Will try out soon to see how it performs pulling 13 tons of machinery in keeping the trans temp cooler!
-
Great product. Fantastic quality. Says what it does, does what it says... Very well. Lowered my EGTs about 200 degrees (steady average), most notably when pulling in LA traffic. I’d definitely recommend this product to anyone looking to help the performance/ longevity of their 4R100.
-
First off, Looks great. Had a shifting issue with my transmission, added this pan, new filter and synthetic fluid and shifting much better. May have also worked with a regular pan but this one gives me a better piece of mind when towing 10,000+ lbs.
-
Wow is this heavy and quality USA made! Acts as a heat sink to absorb heat from the fluid. The 2 front center and 2 back get the short bolts. Diagram shows one on the side getting a short bolt but I had another on the other side requiring a short bolt. Be sure to check the thread embedment. You could have bolts that bottom out and do not seat.
