I purchased a 3 hole overhead console for possible future expansion, loading just EGT and fuel pressure gauges for now. I needed to block off the center hole. This worked for that purpose, but I had to do some filing of the outer diameter surface, and clip out some material between the snaps on each side, to get the plug to go into the existing hole in the overhead gauge pod. It's a bit too big otherwise. For the money and a little time modifying it, it works just fine.

As stated in the first review, this plug does not fit the hole on the autometer pilar guage mount. I had to basically shave the sides down paper thin to get it into the hole. That being said, the face of the plug is wider than the edge of the pilar mount. Granted, it is temporary, but it would be nice if it "fit."

Does the job to plug the hole but I had to trim it alot on the part that fits into the pod. Good thing it is just temporary cause it's not a perfect clean fit.